Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 2022 Nov 25;8(47):eabp9084.
doi: 10.1126/sciadv.abp9084. Epub 2022 Nov 23.

Alteration history of Séítah formation rocks inferred by PIXL x-ray fluorescence, x-ray diffraction, and multispectral imaging on Mars

Affiliations

Alteration history of Séítah formation rocks inferred by PIXL x-ray fluorescence, x-ray diffraction, and multispectral imaging on Mars

Michael M Tice et al. Sci Adv. .

Abstract

Collocated crystal sizes and mineral identities are critical for interpreting textural relationships in rocks and testing geological hypotheses, but it has been previously impossible to unambiguously constrain these properties using in situ instruments on Mars rovers. Here, we demonstrate that diffracted and fluoresced x-rays detected by the PIXL instrument (an x-ray fluorescence microscope on the Perseverance rover) provide information about the presence or absence of coherent crystalline domains in various minerals. X-ray analysis and multispectral imaging of rocks from the Séítah formation on the floor of Jezero crater shows that they were emplaced as coarsely crystalline igneous phases. Olivine grains were then partially dissolved and filled by finely crystalline or amorphous secondary silicate, carbonate, sulfate, and chloride/oxychlorine minerals. These results support the hypothesis that Séítah formation rocks represent olivine cumulates altered by fluids far from chemical equilibrium at low water-rock ratios.

PubMed Disclaimer

Figures

Fig. 1.
Fig. 1.. Minerals and crystallinity.
(A) Reconstructed color stack with red = 735 nm [near infrared (NIR)], green (G) = 530 nm, and blue (B) = 450 nm. Note the abundant tan millimeter-scale grains with dark brown and green patches. PIXL x-ray map areas (B, D, and F) are indicated with dashed white boxes. (B) Areas with no detected diffraction overlaid with slightly transparent yellow. Nondiffracting materials both line visible grain boundaries and cut into grains. (C) Mineral classification ternary diagram using molar abundances, with identified primary (stars) and secondary (hexagons) mineral endmembers indicated. Diffracting spots in green. Nondiffracting spots in black. Carb, (Fe,Mg)-carbonate; LIS, low-(Fe,Mg) silicate. Red, green, and blue channels in (D) indicated next to each pole. (D) False color map of PIXL measurement patches indicating the presence of various minerals. Coloration derived from ternary diagram in (C), with each color channel intensity reflecting closeness to one of the poles: red, FeO-T + MgO; green, CaO + Na2O + K2O; and blue, SiO2. (E) Mineral classification ternary diagram as in (C) but with simple accessory minerals (merrillite, calcium sulfate, magnesium sulfate, and Fe,Cr,Ti-spinels) subtracted to aid in the identification of more common minerals. For comparison, presubtraction spots are shown in gray. Blue lines show modeled mixing relationships resulting from partial overlap between minerals under the PIXL measurement spot. Dashed red line shows mixing relationship that should result from grain contacts between olivine and (Fe,Mg)-carbonate, which is not observed. (F) False color map of PIXL measurement patches showing distribution of saline minerals. Red, CaSO4; green, MgSO4; and blue, NaClO4. Where both sulfate minerals occur together, the combined color is yellow. Sulfate minerals occur in the centers of patches containing other secondary minerals. Perchlorate lines some olivine grains and partially dissects others.
Fig. 2.
Fig. 2.. Mineral endmembers.
In each panel, black spots show no diffraction and green spots show diffraction. Molar abundances in all panels. (A) Sulfate identification. High-SO3 regions are classified as MgSO4 or CaSO4. CaSO4 endmember may incorporate some FeSO4. (B) Cl-bearing endmember classification. Mixing area results from physical mixing of high-Cl phases with variable amounts of high-Na phase (feldspar). For low-Na abundances, Na correlates with Cl with Na/Cl consistent with the PIXL detection of perchlorate. (C) Various endmembers including sulfate minerals, low-(Fe,Mg)-silicate, and (Fe,Mg)-carbonate. (D) Same classification diagram as in (C) but with contributions from sulfate minerals and Fe,Cr,Ti-spinels subtracted from each spot. Unsubtracted data are shown in light gray. Removal of accessory minerals and stability of inferred secondary endmembers are shown by tightening of spots around the remaining endmembers.
Fig. 3.
Fig. 3.. Carbonate in patches enriched in LZE.
Potential concentrations of CO2 for measurements with high LZE, for (a) dispersed spots and (b, d, and e) four patches partially replacing olivine. Patch (c) fills void space defined by dissected olivine grain boundaries. Predicted LZE levels are if all MgO (blue) and FeO (gray) are bound in carbonate minerals compared to the measured LZE level at those locations (green bars). For comparison, faded bars show mass of LZE as hydrated mineral forms of MgO (brucite) and FeO (hisingerite). Compositions are well explained as combinations of (Fe,Mg)-carbonate and olivine or low-(Fe,Mg)-silicate, neither of which contribute CO2. The exception is patch (c), which likely contains undetected H2O from polyhydrated MgSO4. Compositional map as in Fig. 1. wt %, weight %.
Fig. 4.
Fig. 4.. Secondary mineral associations.
False color image of PIXL measurement patches showing associations between secondary minerals [low-(Fe,Mg)-silicate (lis), dull blue-purple; (Fe,Mg)-carbonate (carb), bright red-purple; sulfate minerals (slf), yellow; and NaClO4 (pch), blue] with primary igneous minerals [olivine (ol), red; pyroxene (pyr), dark dull red; mesostasis (mes), black]. Note the partial replacement of olivine by alteration minerals (white arrows) and infilling of dissected olivine grain boundaries by low-(Fe,Mg)-silicate → (Fe,Mg)-carbonate → (Fe,Mg)-carbonate + sulfate minerals (black arrows). Perchlorate is present throughout the alteration assemblage. Color mapping: red, FeOT + MgO – SiO2; green, MgSO4 + CaSO4; and blue, NaClO4. Abundances in millimole per gram of rock, with distributions and color mapping indicated in key. Mineral abundances estimated by mineral stripping.
Fig. 5.
Fig. 5.. Likelihood of observing diffraction from a randomly oriented grain.
Diffraction detected by the PIXL instrument is analogous to a dual detector EDXRD instrument operating in the back reflection geometry. When the broadband x-ray beam is incident on a crystalline sample, many diffraction planes satisfy the Bragg condition. The direction of the vector normal to the diffraction planes (g), together with the energy that satisfies the Bragg condition for energies from 1 to 15 keV, is shown in (A), with the point where the vector intersects a sphere depicted as a circle colored according to its energy. Here, the anisotropic nature of diffraction recorded by PIXL is evident. The vectors gA and gB correspond to the diffraction planes (g) that will be recorded in detectors DA and DB, respectively, where (B) shows the relationship between the vectors gA and gB and the detectors DA and DB. An (hkl) plane diffracting to detector DB is shown. Panel (C) shows the simulated diffraction recorded by PIXL’s detectors for the orientation shown in (A), using the normalized structure factor as a proxy for diffraction intensity, clearly showing different diffraction peaks in each detector. Panel (D) shows the number of reflections recorded in both detectors from 10,000 random x-ray beam-crystal orientations. The (*) indicates no reflections recorded (n = 1851), giving a probability of detecting diffraction from a randomly orientated crystalline grain of 80.5%.
Fig. 6.
Fig. 6.. Pyroxene and olivine grain identification.
Individual grains of pyroxene (A) and olivine (B) are represented by individual colors according to the key in each panel. Grains of the same mineral with small intergrain rotations (D1 P1, D1 P2, and D1 O4, D1 O5) are displayed in similar colors, while clusters that represent no distinct clear cluster (D1 O12, D2 O7, and D2 08) are presented in shades of gray (fig. S2). Note the single poikilitic pyroxene grain intergrown three-dimensionally between olivine grains (black arrows, A) and partially dissected monocrystalline olivine grain (white arrow, B). Spectra from four individual pyroxene and olivine grains from (A) and (B) are shown in (C) and (D), respectively. The colored and black spectra correspond to detector A and B, respectively, as depicted in Fig. 5. Asterisks in (C) and (D) identify intense diffraction peaks in the spectra and correspond to asterisks in the corresponding panels in fig. S2.
Fig. 7.
Fig. 7.. Multispectral band ratio classification.
The three main regions (pyroxene, olivine plus mesostasis, and alteration/secondary) classified based on band ratio histograms. Pyroxene regions show no overlap with alteration regions, indicating that pyroxene is largely unaltered. The boundary between the olivine plus mesostasis region and the altered region is not as well defined but shows a broad transition. As a lower boundary for the fully altered regions, individual thresholds of 0.67, 0.42, and 0.40 for G/NIR, B/NIR, and UV/NIR, respectively, and 0.82, 0.50, and 0.57 are used as upper boundary levels to consider fully altered regions.
Fig. 8.
Fig. 8.. Multispectral classification.
Dourbes target classified into three main regions (pyroxene, olivine and mesostasis, and mesostasis). These images show the classified regions individually in the field of view of the MCC. (A) the full abraded target cleared of dust, (B) the pyroxene regions, (C) the olivine and mesostasis regions, and (D) the alteration regions. On the basis of individual set threshold of the ratio levels, the fully altered regions are separated from the boundary olivine-alteration regions. The resulting distribution is shown in (C1) and (D1) for the olivine and mesostasis plus alteration regions, respectively.
Fig. 9.
Fig. 9.. History of the Dourbes abrasion patch.
Emplacement of olivine cumulate in the Bastide member of the Séítah formation (A) was followed by three successive stages of alteration by or precipitation from water rich in carbonate (B), sulfate (C), or perchlorate (D). Time progresses from top to bottom.
Fig. 10.
Fig. 10.. Automated diffraction identification.
At the left, the learned decision tree (A) splits each data instance into a predicted class based on a series of parameter-value tests. The learned tree classifies spectral peaks as normal, diffraction, surface roughness, or—to minimize false positives—as unknown. At the right, (B) the error analysis of the decision tree using the subject matter expert–labeled data. Columns show the predicted labels, and rows show the true labels. Correct predictions are along the diagonal.

References

    1. M. H. Carr, The Surface of Mars (Yale Univ. Press, 1981), pp. 232.
    1. Ehlmann B. L., Edwards C. S., Mineralogy of the Martian surface. Annu. Rev. Earth Planet. Sci. 42, 291–315 (2014).
    1. J. P. Grotzinger, R. E. Milliken, in Sedimentary Geology of Mars, J. P. Grotzinger, R. E. Milliken, Eds. (SEPM Society for Sedimentary Geology, 2012), vol. 102, pp. 1-48.
    1. Arvidson R. E., Ruff S. W., Morris R. V., Ming D. W., Crumpler L. S., Yen A. S., Squyres S. W., Sullivan R. J., Bell J. F. III, Cabrol N. A., Clark B. C., Farrand W. H., Gellert R., Greenberger R., Grant J. A., Guinness E. A., Herkenhoff K. E., Hurowitz J. A., Johnson J. R., Klingelhöfer G., Lewis K. W., Li R., McCoy T. J., Moersch J., Sween H. Y. M., Murchie S. L., Schmidt M., Schröder C., Wang A., Wiseman S., Madsen M. B., Goetz W., McLennan S. M., Spirit Mars rover mission to the Columbia Hills, Gusev Crater: Mission overview and selected results from the Cumberland Ridge to Home Plate. J. Geophys. Res. 113, E12S33 (2008).
    1. Rampe E. B., Blake D. F., Bristow T. F., Ming D. W., Vaniman D. T., Morris R. V., Achilles C. N., Chipera S. J., Morrison S. M., Tu V. M., Yen A. S., Castle N., Downs G. W., Downs R. T., Grotzinger J. P., Hazen R. M., Treiman A. H., Peretyazhko T. S., Des Marais D. J., Walroth R. C., Craig P. I., Crisp J. A., Lafuente B., Morookian J. M., Sarrazin P. C., Thorpe M. T., Bridges J. C., Edgar L. A., Fedo C. M., Freissinet C., Gellert R., Mahaffy P. R., Newsom H. E., Johnson J. R., Kah L. C., Siebach K. L., Schieber J., Sun V. Z., Vasavada A. R., Wellington D., Wiens R. C.; the MSL Science Team , Mineralogy and geochemistry of sedimentary rocks and eolian sediments in Gale crater, Mars: A review after six earth years of exploration with Curiosity. Geochemistry 80, 125605 (2020).